Alcatel-Lucent 7750 SR OS Service Manual page 1421

count send-count — The number of messages to send, expressed as a decimal integer. The count
timeout seconds — The timeout parameter in seconds, expressed as a decimal integer. This value is
Special Cases
MFIB 224.0.0.X pings — Mfib-ping requests directed to a destination address in the special
Multicast FIB Connectivity Test Sample Output
A:ALA-A# oam mfib-ping service 10 source 10.10.10.1 destination 225.0.0.1 count 2
Seq Node-id
-------------------------------------------------------------------------------
[Send request Seq. 1.]
1
1
1
1
1
[Send request Seq. 2.]
2
2
2
2
2
-------------------------------------------------------------------------------
A:ALA-AIM# oam mfib-ping service 1 source 11.11.0.0 destination 224.0.0.1
Seq Node-id
-------------------------------------------------------------------------------
[Send request Seq. 1.]
1
1
[Echo replies received: 2]
-------------------------------------------------------------------------------
7750 SR OS Services Guide
If the interval is set to 1 second where the timeout value is set to 10 seconds, then the maximum
time between message requests is 10 seconds and the minimum is 1 second. This depends upon
the receipt of a message reply corresponding to the outstanding message request.
Default
1
Values
1 — 10
parameter is used to override the default number of message requests sent. Each message request
must either timeout or receive a reply before the next message request is sent. The message
interval value must be expired before the next message request is sent.
Default
1
Values
1 — 100
used to override the default timeout value and is the amount of time that the 7750 SR will wait
for a message reply after sending the next message request. Upon the expiration of message
timeout, the requesting 7750 SR assumes that the message response will not be received. A
'request timeout' message is displayed by the CLI for each message request sent that expires. Any
response received after the request times out will be silently discarded.
Default
5
Values
1 — 100
224.0.0.X range are flooded throughout the service flooding domain and will receive a response
from all operational SAPs. Note that SAPs that are operationally down do not reply. If EMG is
enabled, mfib-ping will return only the first SAP in each chain.
51.51.51.51:sap1/1/1
54.54.54.54:sap1/1/2
54.54.54.54:sap1/1/3
52.52.52.52:sap1/1/2
52.52.52.52:sap1/1/3
51.51.51.51:sap1/1/1
52.52.52.52:sap1/1/2
54.54.54.54:sap1/1/2
52.52.52.52:sap1/1/3
54.54.54.54:sap1/1/3
10.20.1.3:sap1/1/5:1
10.20.1.3:sap1/1/2:1
OAM and SAA Command Reference
Path
Self
In-Band
In-Band
In-Band
In-Band
Self
In-Band
In-Band
In-Band
In-Band
Path
Not in MFIB Self
Self
Size RTT
100 0ms
100 20ms
100 10ms
100 10ms
100 20ms
100 0ms
100 10ms
100 10ms
100 20ms
100 30ms
Size RTT
40 0ms
40 10ms
Page 1423