Mirror Destination Configuration - Alcatel-Lucent 7750 SR OS Service Manual

Mirror Destination Configuration

far-end
Syntax far-end ip-address [ing-svc-label ing-vc-label | tldp]
no far-end ip-addr
Context config>mirror>mirror-dest>remote-source
Description
This command defines the remote device and configures parameters for mirror destination services
on other devices allowed to mirror to the mirror destination service ID.
The far-end command is used within the context of the remote-source node. It allows the definition
of accepted remote sources for mirrored packets to this mirror-dest-service-id. Up to 50 far-end
sources can be specified. If a far end 7750 SR router has not been specified, packets sent to the router
are discarded.
The far-end command is used to define a remote source 7750 SR that may send mirrored packets to
this 7750 SR for handling by this mirror-dest service-id.
The ing-svc-label keyword must be given to manually define the expected ingress service label. This
ingress label must also be manually defined on the far end address through the mirror-dest SDP
binding keyword egr-svc-label.
The no form of the command deletes a far end address from the allowed remote senders to this mir-
ror-dest service. All far-end addresses are removed when no remote-source is executed. All sig-
naled ingress service labels are withdrawn from the far end address affected. All manually defined
ing-svc-label are removed.
Default
No far end service ingress addresses are defined.
Parameters
ip-address — The service IP address (system IP address) of the remote 7750 SR device sending mir-
ing-svc-label ing-vc-label — Specifies the ingress service label for mirrored service traffic on the far
tldp — Specifies that the label is obtained through signaling via the LDP.
7750 SR OS Services Guide
rored traffic to this mirror destination service. If 0.0.0.0 is specified, any remote 7750 SR is
allowed to send to this service.
Values
1.0.0.1 — 223.255.255.254
The ingress service label must be manually defined using the ing-svc-label keyword. On the far
end 7750 SR, the associated SDP egr-svc-label must be manually set and equal to the label
defined in ing-svc-label.
end device for manually configured mirror service labels.
The defined ing-svc-label is entered into the ingress service label table which causes ingress
packet with that service label to be handled by this mirror-dest service.
The specified ing-svc-label must not have been used for any other service ID and must match the
far end expected specific egr-svc-label for this 7750 SR. It must be within the range specified for
manually configured service labels defined on this 7750 SR. It may be reused for other far end
addresses on this mirror-dest-service-id.
Values
2047 — 18431
Mirror Services
Page 1345