Mirroring Configuration - Alcatel-Lucent 7750 SR OS Service Manual

Service Mirroring

Mirroring Configuration

Configuring mirroring is similar to creating a uni-direction service. Mirroring requires the
configuration of:
•
•
Figure 63
•
•
Page 1302
Mirror source - the traffic on a specific point(s) to mirror.
Mirror destination - the location to send the mirrored traffic, where the sniffer will be
located.
depicts a local mirror service configured on ALA-A.
Port 2/1/2 is specified as the source. Mirrored traffic ingressing and egressing this port
will be sent to port 2/1/3.
SAP 2/1/3 is specified as the destination. The sniffer is physically connected to this port.
Mirrored traffic ingressing and egressing port 2/1/2 is sent here. SAP, encapsulation
requirements, packet slicing, and mirror classification parameters are configured. SDPs
are not used in local mirroring.
2/1/1 2/1/2
Configure a mirror service specifying
source and destination parameters
Figure 3: Local Mirroring Example
ALA-A
2/1/3
7750 SR OS Services Guide
Sniffer
OSSG026