Alcatel-Lucent 7750 SR OS Service Manual page 540

VPLS Service Configuration Commands
If send-queries is not enabled on this SAP or SDP, the configured query-interval value is ignored.
Default
125
Parameters
seconds — The time interval, in seconds, that the router transmits general host-query messages.
query-response-interval
Syntax query-response-interval seconds
Context config>service>vpls>sap>snooping
config>service>vpls>spoke-sdp>snooping
config>service>vpls>mesh-sdp>snooping
Description
If the send-queries command is enabled, this parameter specifies the maximum response time
advertised in IGMPv2/v3 queries.
The configured query-response-interval must be smaller than the configured query-interval.
If send-queries is not enabled on this SAP or SDP, the configured query-response-interval value is
ignored.
Default
10
Parameters
seconds — Specifies the length of time to wait to receive a response to the host-query message from
report-src-ip
Syntax report-src-ip-address
no report-src-ip
Context config>service>vpls>igmp-snooping
Description
This parameter specifies the source IP address used when generating IGMP reports. According the
IGMPv3 standard, a zero source address is allowed in sending IGMP reports. However, for
interoperability with some multicast routers, the source IP address of IGMP group reports can be
configured using this command.
Default
0.0.0.0
Parameters
ip-address — The source IP source address in transmitted IGMP reports.
Page 540
Values
2 — 1024
the host.
Values
1 — 1023
7750 SR OS Services Guide