Alcatel-Lucent 7750 SR OS Service Manual page 1411

Service router - mobile gateway
Hide thumbs Also See for 7750 SR OS:
Table of Contents

Advertisement

bundle-id — Specifies the multilink bundle to be associated with this IP interface. The bundle key-
ima — Specifies Inverse Multiplexing over ATM. An IMA group is a collection of physical links
qtag1, qtag2 — Specifies the encapsulation value used to identify the SAP on the port or sub-port. If
Port Type
Encap-Type
Ethernet
Null
Ethernet
Dot1q
Ethernet
QinQ
SONET/SDH
IPCP
SONET/SDH
BCP-Null
TDM
SONET/SDH
BCP-Dot1q
TDM
SONET/SDH
Frame Relay
TDM
SONET/SDH
ATM
ATM
7750 SR OS Services Guide
If the SONET/SDH port is configured as clear-channel then only the port is specified.
word must be entered at the beginning of the parameter.
The command syntax must be configured as follows:
bundle-id:
bundle-type-slot-id/mda-slot.bundle-num
bundle-id value range: 1 — 128
For example:
*A:ALA-12>config#
*A:ALA-12>config>port# multilink-bundle
bundled together and assigned to an ATM port.
this parameter is not specificially defined, the default value is 0.
Values
qtag1:
qtag2 :
The values depends on the encapsulation type configured for the interface. The following table
describes the allowed values for the port and encapsulation types.
Allowed Values
0
0 — 4094
qtag1: 0 — 4094
qtag2: 0 — 4094
-
0
0 — 4094
16 — 991
vpi (NNI) 0 — 4095
vpi (UNI) 0 — 255
vci 1, 2, 5 — 65535
OAM and SAA Command Reference
port bundle-ima-5/1.1
0 — 4094
* | 0 — 4094
The SAP is identified by the port.
The SAP is identified by the 802.1Q tag on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
The SAP is identified by two 802.1Q tags on the port.
Note that a 0 qtag1 value also accepts untagged packets
on the dot1q port.
The SAP is identified by the channel. No BCP is
deployed and all traffic is IP.
The SAP is identified with a single service on the
channel. Tags are assumed to be part of the customer
packet and not a service delimiter.
The SAP is identified by the 802.1Q tag on the channel.
The SAP is identified by the data link connection
identifier (DLCI).
The SAP is identified by the PVC identifier (vpi/vci).
Comments
Page 1413

Advertisement

Table of Contents
loading

Table of Contents