Alcatel-Lucent 7750 SR OS Service Manual page 885

Table 1: CLI Commands to Configure VPRN Service Parameters (Continued)
Command
hello-multiplier
improved-assert
max-groups
tracking-support
ssm-groups
group-range
no shutdown
Configure VPRN service PIM interface parameters
config>service>vprn>pim>interface
bsm-check-rtr-alert
hello-interval
multicast-senders
priority
tracking-support
no shutdown
config>service>vprn>pim>rp
anycast
rp-set-peer
bootstrap-export
bootstrap-import
bsr-candidate
rp-candidate
7750 SR OS Services Guide
Configures the multiplier to determine the holdtime for a PIM
neighbor.
Enables improved assert processing on this interface.
Configures the maximum number of groups for which PIM can have
downstream state based on received PIM Joins on this interface.
Sets the the T bit in the LAN Prune Delay option of the Hello Message.
Enables access to the context to enable a source-specific multicast
(SSM) configuration instance.
Configures the group address or range of group addresses for which
this router can be the rendezvous point (RP).
Administratively enables the VPRN PIM instance.
Enables the checking of router alert option in the bootstrap messages
received on this interface.
Configures the frequency at which PIM Hello messages are transmitted
on this interface.
Configures the way subnet matching is done for incoming data packets
on this interface.
Sets the priority value to become the rendezvous point (RP) that is
included in bootstrap messages sent by the router.
Sets the the T bit in the LAN Prune Delay option of the Hello Message.
Administratively enables the VPRN PIM interface.
Configures a PIM anycast protocol instance for the RP being
configured.
Configures a peer in the anycast rp-set. The address identifies the
address used by the other node as the RP candidacy address for the
same multicast group address range as configured on this node.
Exports policies to control the flow of bootstrap messages from the RP.
Up to five policies can be defined.
Imports policies to control the flow of bootstrap messages into the RP.
Enables the context to configure a local rendezvous point (RP) of a
PIM protocol instance.
Enables the context to configure the candidate rendezvous point (RP)
parameters.
Virtual Private Routed Network Services
Description Page
1050
1051
1051
1053
1062
1059
951
916
1050
1050
1051
1052
1053
951
1056
1057
1057
1057
1058
1059
Page 885