Alcatel-Lucent 7750 SR OS Service Manual page 1271

Parameters
ccag-id — Identifies the CCAG instance that the system is creating or editing. Up to eight CCAGs
create — The create keyword explicitly indicates that the specified ccag-id is being created.
force — The force keyword removes the specified ccag-id regardless of the presence of one or more
7750 SR OS Services Guide
may be created within the system. A ccag-id must be created on the system prior to creating cross
connect object associations.
After a ccag-id is created, a CCAG SAP may be created with an association with the ccag-id. A
CCAG SAP is identified by a concatenation of an existing ccag-id and a cc-id. The cc-id must
match the cc-id of the other object the CCAG SAP is paired with on the ccag-id. The created
ccag-id may also be associated with a network IP interface. A network IP interface is bound to
the ccag-id through the port command in the config router interface ip-interface context and
references the ccag-id and a cc-id. Again, the cc-id must match the other object the IP interface is
paired with on the ccag-id.
Once created, the ccag ccag-id command may be executed to enter the ccag-id instance for the
purpose of editing the CCAG parameters or operational state.
Values
1 through 8
Handling the inclusion or exclusion state of the create keyword is dependent on the system
environment variable create.
When the system environment variable create is enabled, the system requires the explicit use of
the create keyword when creating objects such as a CCAG. If the keyword is not included and the
ccag-id has not already been created, an error will occur and the CLI will remain at the current
CLI context. This is designed to prevent the inadvertent creation of a CCAG instance in the event
where the wrong ccag-id is specified during an attempt to edit an existing CCAG instance. If the
create keyword is specified, the ccag-id will be created given the ccag-id is within the proper
range for CCAG identifiers.
When the system environment variable create is disabled (using the no create command), the
system will not require the create keyword when creating a CCAG instance. In the event that the
ccag command is issued with a ccag-id that previously had not been created, that ccag-id will be
considered available for cross connect associations and bindings.
Once a ccag-id has been created, the create keyword is ignored when a ccag command is
executed with that ccag-id. The ccag ccag-id create command will only result in a CLI context
change to the specified CCAG instance for a pre-existing ccag-id.
cc-id. If a SAP exists on the ccag-id, the force keyword will cause the SAP to be removed from
the configuration. If a network IP interface is bound to the ccag-id, the interface will be silently
unbound from the ccag-id. The force keyword is intended as a time saving feature, preventing the
need to first remove all service and network associations with the ccag-id.
It is not required to first remove all CCAs from the CCAG prior to deleting the CCAG from the
system. When the CCAG is removed, association with all member CCAs is automatically
removed.
Versatile Service Module
Page 1273