Alcatel-Lucent 7750 SR OS Service Manual page 1077

next-hop-self
Syntax [no] next-hop-self
Context config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description
This command configures the group or neighbor to always set the NEXTHOP path attribute to its
own physical interface when advertising to a peer.
This is primarily used to avoid third-party route advertisements when connected to a multi-access
network.
The no form of the command used at the group level allows third-party route advertisements in a
multi-access network.
The no form of the command used at the neighbor level reverts to the value defined at the group level.
Default
no next-hop-self — Third-party route advertisements are allowed.
passive
Syntax [no] passive
Context config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description
This command enables passive mode for the BGP group or neighbor.
When in passive mode, BGP will not attempt to actively connect to the configured BGP peers but
responds only when it receives a connect open request from the peer.
The no form of the command used at the group level disables passive mode where BGP actively
attempts to connect to its peers.
The no form of the command used at the neighbor level reverts to the value defined at the group level.
Default
no passive — BGP will actively try to connect to all the configured peers.
peer-as
Syntax peer-as as-number
Context config>service>vprn>bgp>group
config>service>vprn>bgp>group>neighbor
Description
This command configures the autonomous system number for the remote peer. The peer AS number
must be configured for each configured peer.
For EBGP peers, the peer AS number configured must be different from the autonomous system
number configured for this router under the global level since the peer will be in a different
autonomous system than this router
7750 SR OS Services Guide
Virtual Private Routed Network Services
Page 1077