Alcatel-Lucent 7750 SR OS Service Manual page 1099

example, if the spf-second-wait interval is 1000, then the next SPF will run after 2000 milliseconds,
and then next SPF will run after 4000 milliseconds, etc., until it reaches the spf-wait value. The SPF
interval will stay at the spf-wait value until there are no more SPF runs scheduled in that interval.
After a full interval without any SPF runs, the SPF interval will drop back to spf-initial-wait.
The timer must be entered in increments of 100 milliseconds. Values entered that do not match this
requirement will be rejected.
Use the no form of this command to return to the default.
Default
no spf-wait
Parameters
max-spf-wait — Specifies the maximum interval in milliseconds between two consecutive SPF
spf-initial-wait — Specifies the initial SPF calculation delay in milliseconds after a topology change.
spf-second-wait — Specifies the hold time in milliseconds between the first and second SPF
lsa-arrival
Syntax lsa-arrival lsa-arrival-time
no lsa-arrival
Context
config>service>vprn>ospf
Description
This parameter defines the minimum delay that must pass between receipt of the same Link State
Advertisements (LSAs) arriving from neighbors.
It is recommended that the neighbors configured (lsa-generate) lsa-second-wait interval is equal or
greater then the lsa-arrival timer configured here.
Use the no form of this command to return to the default.
Default
no lsa-arrival
Parameters
lsa-arrival-time — Specifies the timer in milliseconds. Values entered that do not match this
lsa-generate
Syntax lsa-generate max-lsa-wait [lsa-initial-wait [lsa-second-wait]]
no lsa-generate-interval
7750 SR OS Services Guide
calculations.
Values
1 — 120000
Default
1000
Values
10 — 100000
Default
1000
calculation.
Values
10 — 100000
Default
1000
requirement will be rejected.
Values
0 — 600000
Virtual Private Routed Network Services
Page 1099