Alcatel-Lucent 7750 SR OS Service Manual page 1407

Service router - mobile gateway
Hide thumbs Also See for 7750 SR OS:
Table of Contents

Advertisement

Field
Responders Ingress Ser-
vice Label
Responders Ingress
Label Source
Responders Ingress Ser-
vice Label State
Parameters
ip-address — The far-end IP address to which to send the svc-ping request message in dotted decimal
service service-id — The Service ID of the service being tested must be indicated with this
local-sdp — Specifies the svc-ping request message should be sent using the same service tunnel
7750 SR OS Services Guide
The assigned ingress service label on the remote 7750 SR. This
is the service label that the far end is expecting to receive for
service-id when sending to the originating 7750 SR. If service-id
does not exist in the remote 7750 SR, N/A is displayed. If
service-id exists, but an ingress service label has not been
assigned in the remote 7750 SR, Non-Existent is displayed.
The assigned ingress service label source on the remote 7750
SR. If the ingress service label is manually defined on the
remote 7750 SR, Manual is displayed. If the ingress service label
is dynamically signaled on the remote 7750 SR, Signaled is dis-
played. If the service-id does not exist on the remote 7750 SR,
N/A is displayed.
The assigned ingress service label state on the remote 7750 SR.
If the remote 7750 SR considers its ingress service label opera-
tional, Up is displayed. If the remote 7750 SR considers its
ingress service label inoperative, Down is displayed. If the
service-id does not exist on the remote 7750 SR or the ingress
service label has not been assigned on the remote 7750 SR, N/A
is displayed.
notation.
parameter. The Service ID need not exist on the local 7750 SR to receive a reply message.
Values
1 — 2147483647
encapsulation labeling as service traffic. If local-sdp is specified, the command attempts to use
an egress SDP-ID bound to the service with the specified far-end IP address with the VC-Label
for the service. The far-end address of the specified SDP-ID is the expected responder-id within
the reply received. The SDP-ID defines the encapsulation of the SDP tunnel encapsulation used
to reach the far end; this can be IP/GRE or MPLS. On originator egress, the Service-ID must
have an associated VC-Label to reach the far-end address of the SDP-ID and the SDP-ID must be
operational for the message to be sent.
If local-sdp is not specified, the svc-ping request message is sent with GRE encapsulation with
the OAM label.
The table below indicates whether a message is sent and how the message is encapsulated based
on the state of the Service ID.
OAM and SAA Command Reference
Description
Values (Continued)
resp-ingress-vc-label
N/A
Non-Existent
Manual
Signaled
N/A
Up
Down
N/A
Page 1409

Advertisement

Table of Contents
loading

Table of Contents