Show Commands - Alcatel-Lucent 7750 SR OS Service Manual

Show Commands

egress-label
Syntax egress-label egress-label1 [egress-label2]
Context show>service
Description
Display services using the range of egress labels.
If only the mandatory egress-label1 parameter is specified, only services using the specified label are
displayed.
If both egress-label1 and egress-label2 parameters are specified, the services using the range of labels
X where egress-label1 <= X <= egress-label2 are displayed.
Use the show router ldp bindings command to display dynamic labels.
Parameters
egress-label1 — The starting egress label value for which to display services using the label range. If
egress-label2 — The ending egress label value for which to display services using the label range.
Output Show Service Egress Command Output — The following table describes show service
egress label output fields.
Table 8: Show Service Egress Label Output Fields
Sample Output
*A:ALA-12# show service egress-label 0 10000
7750 SR OS Services Guide
only egress-label1 is specified, services only using egress-label1 are displayed.
Values
0, 2049 — 131071
Default
The egress-label1 value.
Values
2049 — 131071
Label
Svc Id
Sdp Id
Type
I. Lbl
E. Lbl
Number of bindings
found
Virtual Private Routed Network Services
The ID that identifies a service.
The ID that identifies an SDP.
Indicates whether the SDP binding is a spoke or a mesh.
The VC label used by the far-end device to send packets to this device
in this service by the SDP.
The VC label used by this device to send packets to the far-end device
in this service by the SDP.
The total number of SDP bindings that exist within the specified egress
label range.
Description
Page 1109