Configuring A Remote Mirror Service - Alcatel-Lucent 7750 SR OS Service Manual

Common Configuration Tasks

Configuring a Remote Mirror Service

For remote mirroring, the source and destination are configured on the different routers. Note that
mirror source and mirror destination parameters must be configured under the same service ID
context.
The
mirror-source
mirrored at the source. For example, use the
[ingress]}
commands.
Use the CLI syntax to configure one or more mirror source parameters:
CLI Syntax: debug> mirror-source service-id
The
mirror-dest
forwarding class, and the size of the packet. Use the following CLI syntax to configure mirror
destination parameters:
CLI Syntax: config>mirror#
Page 1330
commands are used as traffic selection criteria to identify traffic to be
and
mac-filter mac-filter-id entry entry-id [entry-id ...]
ip-filter ip-filter-id entry entry-id [entry-id ...]
ingress-label label [label ...]
mac-filter mac-filter-id entry entry-id [entry-id ...]
port {port-id|lag lag-id} {[egress][ingress]}
sap sap-id {[egress][ingress]}
sdp sdp-id:[vc-id] {[egress] [ingress]}
no shutdown
commands are used to specify where the mirrored traffic is to be sent, the
mirror-dest service-id [type {ether|frame-relay|ppp|atm-
sdu}]
description string
fc fc-name
remote-source
far-end ip-addr ing-svc-label ing-svc-label
sap sap-id
sdp sdp-id[:vc-id][egr-svc-label [label|tldp]
no shutdown
slice-size bytes
port port-id[.channel-id] {[egress]
7750 SR OS Services Guide