Alcatel-Lucent 7750 SR OS Service Manual page 1427

falling-threshold threshold — Specifies a falling threshold loss event value. When the test run is
direction — Specifies the direction for OAM ping responses received for an OAM ping test run.
type
Syntax type
no type
Context config>saa>test
Description
This command creates the context to provide the test type for the named test. Only a single test type
can be configured.
A test can only be modified while the test is in shut down mode.
Once a test type has been configured the command can be modified by re-entering the command, the
test type must be the same as the previously entered test type.
To change the test type, the old command must be removed using the config>saa>test>no type
command.
cpe-ping
Syntax cpe-ping service service-id destination ip-address source ip-address [ttl vc-label-ttl]
[return-control] [source-mac ieee-address] [fc fc-name [profile [in | out]] [interval
interval] [count send-count] [send-control]
Context <GLOBAL>
config>saa>test>type
Description
This ping utility determines the IP connectivity to a CPE within a specified VPLS service.
7750 SR OS Services Guide
completed, the calculated loss event value is compared to the configured loss event falling
threshold. If the test run loss event value is greater than the configured falling threshold value
then an SAA threshold event is generated. The SAA threshold event is tmnxOamSaaThreshold,
logger application OAM, event #2101.
Default
0
Values
0 — 2147483647 packets
Values
inbound — Monitor the value of jitter calculated for the inbound, one-way, OAM
ping responses received for an OAM ping test run.
outbound — Monitor the value of jitter calculated for the outbound, one-way,
OAM ping requests sent for an OAM ping test run.
roundtrip — Monitor the value of jitter calculated for the round trip, two-way,
OAM ping requests and replies for an OAM ping test run.
Default
roundtrip
OAM and SAA Command Reference
Page 1429