Alcatel-Lucent 7750 SR OS Service Manual page 917

Configuring a VPRN Interface SAP
VPRN Interface SAP
A SAP is a combination of a port and encapsulation parameters which identifies the service access
VPRN interface
point on the interface and within the SR. Each SAP must be unique within a router. A SAP cannot
be defined if the interface
When configuring VPRN interface SAP parameters, a default QoS policy is applied to each
ingress and egress SAP. Additional QoS policies and scheduler policies must be configured in the
config>qos
explicitly applied to a SAP. There are no default filter policies.
VPRN interface ATM SAP parameters can only be configured on ATM-type MDAs and ATM-
configured ports. The
config>system>atm>oam
Guide.
Refer to
The following displays the command usage to configure VPRN interface SAP parameters:
Example
7750 SR OS Services Guide
loopback
context. Filter policies are configured in the
periodic-loopback
context is enabled. See the 7750 SR OS Basic System Configuration
OSPF Configuration Commands on page 943
:
config>service# vprn 1
config>service>vprn# interface "to-cel"
config>service>vprn>if# sap 1/1/10:1
config>service>vprn>if>sap# egress
config>service>vprn>if>sap>egress# filter ip 6
config>service>vprn>if>sap>egress# qos 1010
config>service>vprn>if>sap>egress# scheduler-policy SLA1
config>service>vprn>if>sap>egress# exit
config>service>vprn>if>sap# ingress
config>service>vprn>if>sap>ingress# qos 100
config>service>vprn>if>sap>ingress# scheduler-policy SLA2
config>service>vprn>if>sap>ingress# exit
Virtual Private Routed Network Services
command is enabled.
config>filter
command can only be enabled when the
for CLI commands and syntax.
context and must be
Page 917