Alcatel-Lucent 7750 SR OS Service Manual page 734

IES Service Configuration Commands
Description
This command specifies the BFD parameters for the associated IP interface. If no parameters are
defined the default value are used.
The multiplier specifies the number of consecutive BFD messages that must be missed from the peer
before the BFD session state is changed to down and the upper level protocols (OSPF, IS-IS or PIM)
is notified of the fault.
The no form of the command removes BFD from the associated IGP protocol adjacency.
Default
no bfd
Parameters
transmit-interval — Sets the transmit interval for the BFD session.
receive receive-interval — Sets the receive interval for the BFD session.
multiplier multiplier — Set the multiplier for the BFD session.
cflowd
Syntax cflowd {acl | interface}
no cflowd
Context config>service>ies>interface
Description
This command enables cflowd to collect traffic flow samples through a router for analysis.
cflowd is used for network planning and traffic engineering, capacity planning, security, application
and user profiling, performance monitoring, usage-based billing, and SLA measurement. When
cflowd is enabled at the interface level, all packets forwarded by the interface are subjected to
analysis according to the cflowd configuration.
Default
no cflowd
Parameters
ACL — cflowd configuration associated with a filter.
interface — cflowd configuration associated with an IP interface.
local-proxy-arp
Syntax [no] local-proxy-arp
Context config>service>ies>interface
config>service>ies>sub-if>grp-if
Page 734
Values
100 — 100000
Default
100
Values
100 — 100000
Default
100
Values
2 — 20
Default
3
7750 SR OS Services Guide