Alcatel-Lucent 7750 SR OS Service Manual page 1481

Syntax psb [endpoint endpoint-address] [sender sender-address] [tunnelid tunnel-id] [lspid lsp-
id]
Context tools>dump>router>rsvp
Description
This command displays path state block (PSB) information for RSVP.
When a PATH message arrives at an LSR, the LSR stores the label request in the local PSB for the
LSP. If a label range is specified, the label allocation process must assign a label from that range.
The PSB contains the IP address of the previous hop, the session, the sender, and the TSPEC. This
information is used to route the corresponding RESV message back to LSR 1.
Default
none
Parameters
endpoint endpoint-address — Specifies the IP address of the last hop.
sender sender-address — Specifies the IP address of the sender.
tunnelid tunnel-id — Specifies the SDP ID.
lspid lsp-id — Specifies the label switched path that is signaled for this entry.
rsb
Syntax rsb [endpoint endpoint-address] [sender sender-address] [tunnelid tunnel-id] [lspid lsp-id]
Context tools>dump>router>rsvp
Description
This command displays RSVP Reservation State Block (RSB) information.
Default
none
Parameters
endpoint endpoint-address — Specifies the IP address of the last hop.
sender sender-address — Specifies the IP address of the sender.
tunnelid tunnel-id — Specifies the SDP ID.
lspid lsp-id — Specifies the label switched path that is signaled for this entry.
tcsb
Syntax tcsb [endpoint endpoint-address] [sender sender-address] [tunnelid tunnel-id] [lspid lsp-
id]
Context tools>dump>router>rsvp
Description
This command displays RSVP traffic control state block (TCSB) information.
Default
none
7750 SR OS Services Guide
Values
0 — 4294967295
Values
1 — 65535
Values
0 — 4294967295
Values
1 — 65535
Tools
Page 1483