Alcatel-Lucent 7750 SR OS Service Manual page 1096

VPRN Service Configuration Commands
overload-include-stub
Syntax [no] overload-include-stub
Context config>service>vprn>ospf
Description
This command is used to to determine if the OSPF stub networks should be advertised with a
maximum metric value when the system goes into overload state for any reason. When enabled, the
system uses the maximum metric value. When this command is enabled and the router is in overload,
all stub interfaces, including loopback and system interfaces, will be advertised at the maximum
metric.
Default
no overload-include-stub
overload-on-boot
Syntax overload-on-boot [timeout seconds]
no overload
Context config>service>vprn>ospf
Description
When the router is in an overload state, the router is used only if there is no other router to reach the
destination. This command configures the IGP upon bootup in the overload state until one of the
following events occur:
The no form of the command removes the overload-on-boot functionality from the configuration.
Default
no overload-on-boot
Parameters
timeout seconds — Specifies the number of seconds to reset overloading.
preference
Syntax preference preference
no preference
Context config>service>vprn>ospf
This command configures the preference for OSPF internal routes.
Page 1096
Values
60 —1800
Default
60
• The timeout timer expires.
• A manual override of the current overload state is entered with the no overload command.
The no overload command does not affect the overload-on-boot function.
Values
60 —1800
Default
60
7750 SR OS Services Guide