Alcatel-Lucent 7750 SR OS Service Manual page 915

Configuring VPRN Protocols - OSPF
Each VPN routing instance is isolated from any other VPN routing instance, and from the routing
VPRN interface
used across the backbone. OSPF can be run with any VPRN, independently of the routing
protocols used in other VPRNs, or in the backbone itself. For more information about the OSPF
protocol, refer to the 7750 SR OS Router Configuration Guide.
CLI Syntax: config>service>vprn>ospf#
VPRN OSPF CLI Syntax
Refer to
parameters.
The following example displays the command usage to create an VPRN OSPF interface and
configure area parameters:
Example
The following example displays the VPRN OSPF configuration shown above:
A:debby-sim1>config>service# info
----------------------------------------------
vprn 2 customer 1 create
----------------------------------------------
A:debby-sim1>config>service#
For more information about the OSPF protocol, refer to the 7750 SR OS Router Configuration
Guide
7750 SR OS Services Guide
OSPF Configuration Commands on page 943
:
config>service# vprn 2 customer 1 create
config>service>vprn# ospf
config>service>vprn>ospf# interface test create
config>service>vprn>ospf>if$ exit
config>service>vprn>ospf>if$ no shutdown
config>service>vprn>ospf# area 0.0.0.0
config>service>vprn>ospf>area# virtual-link 1.2.3.4
transit-area 1.2.3.4
config>service>vprn>ospf>area>virtual-link# hello-interval 9
config>service>vprn>ospf>area>virtual-link# dead-interval 40
config>service>vprn>ospf>area>virtual-link# exit
interface "test" create
exit
no shutdown
exit
area 0.0.0.0
virtual-link 1.2.3.4 transit-area 1.2.3.4
hello-interval 9
dead-interval 40
exit
exit
Virtual Private Routed Network Services
for CLI syntax to configure VPRN
Page 915