List Of Commands - Alcatel-Lucent 7750 SR OS Service Manual

Configuring VSM and CCAG with CLI

List of Commands

Table 40
indicating the configuration level at which each command is implemented with a short command
description. The command list is organized in the following task-oriented manner:
•
•
•
•
•
•
•
•
Table 1: CLI Commands to Configure VSM Parameters
Command
Configure VSM
config>vsm
vsm
ccag
access
adapt-qos
cca-rate
description
member-cca
shutdown
Configure VSM path parameters
config>vsm>path
path
sap-sap
sap-net
net-sap
Page 1240
lists all the configuration commands to provision VSM and service-related commands,
Configure VSM on page 1240
Configure VSM path parameters on page 1240
Configure VSM on an MDA on page 1241
Configure CCAG on a router interface port on page 1241
Configure CCAG on an Epipe service on page 1241
Configure CCAG on a VPLS service on page 1241
Configure CCAG on an IES service on page 1242
Configure CCAG on an VPRN service on page 1242
Changes the current CLI context to the CCA nodal context.
Creates a Cross Connect Aggregation Group (CCAG).
Changes the current CLI context to the CCAG access nodal context.
Controls how the CCAG SAP queue and virtual scheduler buffering and
rate parameters are adapted over multiple active CCAs.
Defines a maximum forwarding rate for each CCA member within the
CCAG.
Defines an informational string associated with the CCAG.
Adds and deletes provisioned CCAs from the CCAG.
Controls the administrative state of that the command is executed under.
Changes the current CLI context to the path nodal context.
Changes the current CLI context to the path sap-sap nodal context.
Changes the current CLI context to the path sap-net nodal context.
Changes the current CLI context to the path net-sap nodal context.
Description
7750 SR OS Services Guide
Page
1272
1272
1274
1274
1274
1271
1275
1271
1276
1278
1281
1281