Configuring Vrrp - Alcatel-Lucent 7750 SR OS Service Manual

Configuring an IES Service with CLI

Configuring VRRP

Configuring VRRP parameters on an IES interface is optional. VRRP can be configured in either
an owner or non-owner mode. The owner is the VRRP router whose virtual router IP address is the
same as the real interface IP address. This is the router that responds to packets addressed to one of
the IP addresses for ICMP pings, TCP connections, etc. All other virtual router instances
participating in this message domain must have the same VRID configured and cannot be
configured as owner.
For further information about VRRP CLI syntax and command descriptions refer to the 7750 SR
OS Router Configuration Guide.
Use the following CLI syntax to configure non-owner VRRP IES interface parameters.
CLI Syntax:config>service# ies service-id
Use the following CLI syntax to configure owner VRRP IES interface parameters.
CLI Syntax:config>service> ies service-id
Page 698
interface ip-int-name
vrrp vrid
authentication-key [authentication-key | hash-key] [hash]
authentication-type {password | message-digest}
backup ip-addr
mac ieee-mac-address
master-int-inherit
priority
policy (vrrp instance) vrrp-policy-id
preempt
message-interval seconds
ping-reply
ssh-reply
telnet-reply
traceroute-reply
no shutdown
interface ip-int-name
vrrp vrid owner
authentication-type {password | message-digest}
authentication-key [authentication-key | hash-key] [hash]
backup ip-addr
mac ieee-mac-address
message-interval seconds
7750 SR OS Services Guide