Alcatel-Lucent 7750 SR OS Service Manual page 782

Service router - mobile gateway
Hide thumbs Also See for 7750 SR OS:
Table of Contents

Advertisement

IES Service Configuration Commands
The no form of this command removes the QoS policy association from the SAP or IP interface, and
the QoS policy reverts to the default.
policy-id — The ingress/egress policy ID to associate with SAP or IP interface on ingress/egress. The
shared-queuing — This keyword can only be specified on SAP ingress. Specify the ingress shared
multipoint-shared — This keyword specifies that this queue-id is for multipoint forwarded traffic
queue-override
Syntax
[no] queue-override
Context
config>service>ies>if>sap>egress
config>service>ies>if>sap>ingress
Description
This command enables the context to configure override values for the specified SAP egress QoS
queue. These values override the corresponding ones specified in the associated SAP egress or
ingress QoS policy.
queue
Syntax
[no] queue queue-id
Context
config>service>ies>if>sap>egress>queue-override
config>service>ies>if>sap>ingress>queue-override
Description
This command specifies the ID of the queue whose parameters are to be overridden.
Parameters
queue-id — The queue ID whose parameters are to be overridden.
Page 782
policy ID must already exist.
Values
1 — 65535
queue policy used by this SAP. When the value of this object is null it means that the SAP will
use individual ingress QoS queues, instead of the shared ones.
only. This queue-id can only be explicitly mapped to the forwarding class multicast, broadcast, or
unknown unicast ingress traffic. If you attempt to map forwarding class unicast traffic to a
multipoint queue, an error is generated and no changes are made to the current unicast traffic
queue mapping.
A queue must be created as multipoint. The multipoint designator cannot be defined after the
queue is created. If an attempt is made to modify the command to include the multipoint
keyword, an error is generated and the command will not execute.
The multipoint keyword can be entered in the command line on a pre-existing multipoint queue
to edit queue-id parameters.
Values
1 — 32
7750 SR OS Services Guide

Advertisement

Table of Contents
loading

Table of Contents