Alcatel-Lucent 7750 SR OS Service Manual page 801

The no form of this command prevents a non-owner virtual router instance from preempting another,
less desirable virtual router. Use the preempt command to restore the default mode.
Default
preempt
priority
Syntax priority base-priority
no priority
Context config>service>ies>if>vrrp
Description
The priority command provides the ability to configure a specific priority value to the virtual router
instance. In conjunction with an optional policy command, the base-priority is used to derive the in-
use priority of the virtual router instance.
The priority command is only available in the non-owner vrrp virtual-router-id nodal context. The
priority of owner virtual router instances is permanently set to 255 and cannot be changed. For non-
owner virtual router instances, if the priority command is not executed, the base-priority will be set to
100.
The no form of this command restores the default value of 100 to base-priority.
Parameters
base-priority — The base-priority parameter configures the base priority used by the virtual router
instance. If a VRRP Priority Control policy is not also defined, the base-priority will be the in-use
priority for the virtual router instance.
standby-forwarding
Syntax [no] standby-forwarding
Context config>service>ies>if>vrrp
Description
This command allows the forwarding of packets by a standby router.
The no form of the command specifies that a standby router should not forward traffic sent to virtual
router's MAC address. However, the standby router should forward traffic sent to the standby router's
real MAC address.
Default
no standby-forwarding
ssh-reply
Syntax ssh-reply
7750 SR OS Services Guide
• Greater than the virtual router in-use priority value
• Equal to the in-use priority value and the source IP address (primary IP address) is greater than
the virtual router instance primary IP address
Values
1 — 254
Default
100
Internet Enhanced Services
Page 801