Alcatel-Lucent 7750 SR OS Service Manual page 762

IES Service Configuration Commands
IES Spoke SDP Commands
spoke-sdp
Syntax spoke-sdp sdp-id[:vc-id]
no spoke-sdp sdp-id[:vc-id]
Context config>service>ies>interface
config>service>ies>redundant-interface
Description
This command binds a service to an existing Service Distribution Point (SDP).
A spoke SDP is treated like the equivalent of a traditional bridge "port" where flooded traffic received
on the spoke SDP is replicated on all other "ports" (other spoke and mesh SDPs or SAPs) and not
transmitted on the port it was received.
The SDP has an operational state which determines the operational state of the SDP within the
service. For example, if the SDP is administratively or operationally down, the SDP for the service
will be down.
The SDP must already be defined in the config>service>sdp context in order to associate an SDP
with an IES service. If the sdp sdp-id is not already configured, an error message is generated. If the
sdp-id does exist, a binding between that sdp-id and the service is created.
SDPs must be explicitly associated and bound to a service. If an SDP is not bound to a service, no far-
end devices can participate in the service.
The no form of this command removes the SDP binding from the service. The SDP configuration is
not affected; only the binding of the SDP to a service. Once removed, no packets are forwarded to the
far-end router. The spoke SDP must be shut down first before it can be deleted from the configuration.
Default
No sdp-id is bound to a service.
Special Cases IES — At most, only one sdp-id can be bound to an IES service.
Parameters
sdp-id — The SDP identifier. Allowed values are integers in the range of 1 and 17407 for existing
vc-id — The virtual circuit identifier.
egress
Syntax egress
Context config>service>ies>>if>spoke-sdp
config>service>ies>redundant-interface>spoke-sdp
Description
This command configures the egress SDP context.
Page 762
SDPs.
Values
1 — 4294967295
7750 SR OS Services Guide