Changing The Paper Size For Tray 3 (When Tandem Tray Module Is Installed) - Fuji Xerox ApeosPort-V C6676 Administrator's Manual

4
Load and align the edge of the paper against
the left side of the tray, with the side to be
copied or printed on facing up.
Important • Do not load paper above the maximum fill
5
Push the tray in gently until it stops.
Important • When inserting the tray, push it gently. Forcibly pushing the tray in may cause machine malfunction.
Note
For more information on paper type settings, refer to "Changing the Paper Settings" (P.72).

Changing the Paper Size for Tray 3 (When Tandem Tray Module is Installed)

The following describes how to change paper size in Tray 3 when the Tandem Tray Module
is installed.
1
Pull out Tray 3 until it stops.
CAUTION
Make sure to pull out the tray
slowly. When the tray is being
pulled out with force, the tray
may possibly hit your knees or
other parts of your body
causing injuries.
Important • While the machine is processing a job, do not pull out the tray that is being used for the job.
2
Remove any paper loaded in the tray.
3
Pinch the paper guide and slide it to the desired
paper size.
line ("MAX" in the right figure).
• Affix the paper size label to the front of the paper tray.
• To prevent paper jams or erroneous detection of loaded paper in a tray by the machine, do not add
paper on top of any remaining paper in the tray.
Changing the Paper Size
67
2