Loading Paper In Tray 5 (Bypass) - Fuji Xerox Versant 80 Press User Manual

3 Paper and Other Media

Loading Paper in Tray 5 (Bypass)

When printing or copying with paper sizes or types that cannot be loaded on paper that has
not been loaded or with the paper size that cannot be loaded in Trays 1 to 3, 6 (optional)
and 7 (optional), use Tray 5 (Bypass).
Note
1
Open Tray 5 (Bypass).
Note
2
Hold the center of the paper guides and slide
3
them to the desired paper size.
3
Load paper with the side to be copied or
printed on facing up, and insert the paper
lightly along the paper guide until it stops.
Important • Do not load mixed paper types into the tray.
Note
4
When loading a non-standard paper size, slightly move the paper guides to the desired
paper size.
106
• Remove any paper remaining in Tray 5, and then load that paper on top of the newly loaded paper.
• Carefully fan the paper before loading it in a tray. Otherwise, paper jams may occur or multiple
sheets may be fed to the machine simultaneously.
• If necessary, extend the extension flap. The
extension flap can be extended in two stages.
When pulling out the extension flap, do it
gently.
• The extension flap is not installed in the HCF
B1-S and the High Capacity Feeder C3-DS.
Proceed to step 2.
• Do not load paper exceeding the maximum
fill line ("MAX" in the right figure). It may
cause paper jams or machine malfunctions.
• When loading a postcard, place its bottom
edge along the machine.
• When loading envelope with the flap
opening, place the bottom edge of the envelope (not the flap side) along the machine. When
loading envelope with the flap closing, place the flap along the machine or to the front side of the
machine. When loading adhesive envelope, place it with the flap closing. When loading envelope
with the flap closing and the flap placing to the front side of the machine, note that the quality of
the image printed on the trailing edge of the envelope may become poor.
• Load paper straight along the paper guides; otherwise, the paper may be jammed or the printed
result may be skewed.