Fuji Xerox Versant 80 Press User Manual page 787

Error Code
017-765 [Cause] An error occurred in connecting to the POP3 server.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
017-766
[Cause] An error occurred in connecting to the POP3 server. Probable causes are follows.
1)When connecting to the POP3 server by the TLS communication, the port number is
2)When connecting to the POP3 server by the SSL communication, an internal error
[Remedy] For 1, set the correct port number for the POP3 server.
For 2, switch off the machine power, make sure that the touch screen is blank, and then
switch on the machine power. If the error still is not resolved, contact our Customer
Support Center.
017-767 [Cause] A SSL server authentication error occurred because the server certificate for the POP3
server is invalid.
[Remedy] Use the valid server certificate for the POP3 server.
017-768 [Cause] The server certificate for the POP3 server is before the valid period.
[Remedy] Be sure to match the time set on the POP3 server and the machine. If the time matches,
use the valid server certificate.
017-769 [Cause] The server certificate for the POP3 server is expired.
[Remedy] Be sure to match the time set on the POP3 server and the machine. If the time matches,
use the valid server certificate.
017-770
[Cause] The server addresses of the POP3 server and the server certificate are not same.
[Remedy] Use the valid server certificate in which the correct server address is written.
017-771 [Cause] An error occurred.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
017-772
[Cause] The scanned documents is completely blank.
[Remedy] Take one of the following measures.
If the error still is not resolved, contact our Customer Support Center.
017-780 [Cause] When [Enabled] is set to [Auto Job Promotion], a bypassed job is automatically deleted
after a certain period of time.
[Remedy] No measure is required.
Note • If necessary, change the setting by set [Disabled] or specify the period of time until a bypassed
017-782 [Cause] An internal error occurred during image processing.
[Remedy] Execute the operation again. If the error still is not resolved, contact our Customer
Support Center.
017-783 [Cause] The memory became insufficient during image processing.
[Remedy] Take one of the following measures:
Cause and Remedy
incorrect.
occurred.
Check whether the document is blank or whether the document to be scanned is
loaded correctly.
Select [Image option] in the [Advanced Settings] screen and set the scan density to
be [Darken].
job is deleted between 1 minute and 120 hours.
Transmit data with lower resolution.
Transmit data in the setting [Output Color] to [Black & White].
Error Code
22
787