Fuji Xerox Versant 80 Press User Manual page 847

Error Code
121-310 [Cause] An error occurred in the machine.
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
121-311 [Cause] An error occurred between the machine and the device connected.
[Remedy] Once IC Card Reader is connected to the machine, the machine automatically changes
the [Smart Card Link Mode] setting to [Type Password] under [Tools] > [Authentication/
Security Settings] > [Authentication] > [User Details Setup]. Change the setting as
required.
121-312
[Cause] An error occurred between the machine and the device connected.
121-313
[Remedy] Switch on the machine power without connecting the device for EP system, and then set
[Login Type] to any option other than [Login to Remote Accounts] under [Tools] >
[Authentication/Security Settings] > [Authentication].
121-314
[Cause] An error occurred between the machine and the device connected.
121-316
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
121-318
on the machine power. If the same message is displayed again, contact our Customer
121-319
Support Center.
121-320
121-321
121-322
121-323
121-325 [Cause] The machine detects unacceptable combination.
The unacceptable combination are as follows:
[Remedy] Take one of the following measures:
121-333 [Cause] An error occurred between the machine and the device connected.
[Remedy] Confirm that the device is switched on, and then switch off the machine power, make
sure that the touch screen is blank, and switch on the machine power. If the error still is
not resolved, contact our Customer Support Center.
121-334
[Cause] An error occurred between the machine and the device connected.
121-335
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
121-336
on the machine power. If the same message is displayed again, contact our Customer
121-337 Support Center.
121-338
121-340 [Cause] An error occurred between the machine and the device connected.
121-350
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
121-370
on the machine power. If the same message is displayed again, contact our Customer
Support Center.
Cause and Remedy
Both the USB IC card reader and the EP related equipment are used
[Login to Local Accounts] is set to [Login Type]
[Smart Card or Control Panel Login] is set to [When Smart Card Reader is Connected]
When both Smart Card and Control Panel Login are not used, the setting of [When
Smart Card Reader is Connected] will be automatically changed to [Smart Card
Login]. No measure is required.
When only the USB IC card reader is connected to the machine and both Smart Card
and Control Panel Login are used, contact our Customer Support Center.
Error Code
22
847