Fuji Xerox Versant 80 Press User Manual page 59

C3 Finisher (optional), C3 Finisher with Booklet Maker (optional)
No. Component
1 Transport Unit V1 front door
2 Hole punch waste container
3 Output tray
4 Finisher tray
5 Staple cartridge
6 *
Booklet tray
7 Finisher front door
8 *
Booklet unit
9
Booklet staple cartridges
* : Available when the C3 Finisher with Booklet Maker is installed
Note • In this guide, "C3 Finisher" and "C3 Finisher with Booklet Maker" are referred to as "finisher".
1 2
9 8
Open this door to clear paper jams.
Collects punch scraps from the puncher. Remove this container when
discarding the punch scraps.
Outputs are delivered here.
Outputs are delivered here.
Staples are stored in this cartridge. Pull out this cartridge to replace staples
or clear staple jams.
Bound booklets are delivered here.
Open this door to clear paper or staple jams, replace staples, or discard
punch scraps.
This unit is for folding outputs in half and stapling the folded outputs.
* Two staple cartridges for booklet creation. Take out the cartridges when
clearing staple jams, or when replacing them with new ones.
Machine Components
Function
3
4
5
2
6
7
59