Fuji Xerox Versant 80 Press User Manual page 178

4 Copy
Booklet Trimming/Pressing
This option is displayed if you select [Fold Only] or [Fold & Staple] when the Square Fold &
Trimmer Module (optional) is installed.
You can specify whether to trim the fore edge of a booklet, and whether to press the booklet
spine.
Refer to "[Booklet Trimming/Pressing] Screen" (P.178).
[Booklet Trimming/Pressing] Screen
When the Square Fold & Trimmer Module (optional) is installed, [Trimming] and [Book
Pressing] become available if you select [Fold Only] or [Fold & Staple] on the [Booklet
Creation - Fold & Staple] screen.
Trimming is a feature that trims the fore edge of a booklet, which is opposite of the booklet
spine, in order to finish the edge neatly.
Book Pressing is a feature that presses the spine of a booklet to flatten the spine.
4
Important • If outputs are not stapled, or if a finished booklet is four pages or less, paper may be jammed or
1
Select any option.
Trimming
Off
Does not trim the fore edge of booklets.
On
Trims the fore edge of booklets.
Paper Supply
Displays [Paper Supply] screen.
Select the paper tray with paper loaded in landscape orientation (
Cut to Size
Displays the width of a finished booklet after being trimmed by the amount specified in
[Default Trim Margin]. Change the value as necessary.
You can set [Default Trim Margin] in the System Administration mode. For more information, refer to "Default Trim Margin"
(P.465).
178
Trimming
Booklet Pressing
wrinkled, resulting in a poor shaped spine.
).