Fuji Xerox Versant 80 Press User Manual page 778

22 Problem Solving
Error Code
016-707 [Cause]
[Remedy] To use the Sample Set feature, the hard disk must be installed. Contact our Customer
016-708
[Cause]
[Remedy] Delete unnecessary data from the hard disk to free up disk space.
016-709 [Cause]
[Remedy] Contact our Customer Support Center.
016-710 [Cause]
[Remedy] Contact our Customer Support Center.
016-711 [Cause]
[Remedy] Take one of the following measures, and then try sending the mail again.
016-712 [Cause]
[Remedy] Increase the resolution or scan area.
22
016-713 [Cause]
[Remedy] Enter the correct passcode.
016-714 [Cause]
[Remedy] Create a new folder or specify an existing folder.
016-715
[Cause]
[Remedy] Enter the correct password of the ESCP form.
016-716 [Cause]
[Remedy] Delete unnecessary files and users from the machine.
Refer to "Printing and Deleting Stored Jobs" (P.362).
016-718 [Cause]
[Remedy] Reduce the resolution, or cancel 2 sided printing or N up feature, and then print again.
016-719
[Cause]
[Remedy] Increase the size of the print page buffer.
016-720 [Cause]
[Remedy] Confirm the print data and try printing again.
016-721 [Cause]
[Remedy] For 1), when printing by the Auto Paper selection, set one of the paper types to other
Refer to "Paper Tray Priority" (P.433).
778
Cause and Remedy
Unable to print with the Sample Set feature because the hard disk is not installed.
Support Center.
Unable to annotate because of insufficient hard disk space.
An error occurred during print processing.
Unable to register the Delayed Print document because the hard disk is defective.
The upper limit for the e-mail size has been exceeded.
Reduce the number of pages of the document.
Lower the resolution with [Resolution].
Reduce the magnification with [Reduce/Enlarge].
Ask your system administrator to increase the value set for [Maximum Total Data
Size].
For color scanning, set [MRC High Compression] to [On] under [File Format].
Unable to process the document because the specified scan area is too small.
The passcode entered does not match the passcode set on the folder.
The specified folder does not exist.
The machine failed to access the ESCP form because the password of the ESCP form
does not match.
Unable to spool TIFF file because of insufficient hard disk space.
Unable to process the PCL print data because of insufficient memory.
Unable to process the PCL print data because of insufficient print page buffer.
An invalid command is included in PCL print data.
An error occurred during print processing. Probable causes are as follows:
1)Printing was instructed by the Auto Paper selection when [Paper Tray Priority] is set to
[Auto Paper Off] for all paper in the [Common Service Settings].
2)ESC/P-K command error occurred.
than [Auto Paper Off] in [Paper Tray Priority].
For 2), confirm the print data.