Loading Postcards - Fuji Xerox Versant 80 Press User Manual

Loading Tab Paper in Tray T1 (Inserter)
1
Hold the center of the paper guides and slide
them to the desired paper size.
2
If the paper is already printed on, load the
paper with the printed side facing up and with
the tab side to be fed first.
Important • Do not load paper exceeding the maximum

Loading Postcards

Postcards can be loaded in Tray 5 (Bypass), the HCF B1-S (Tray 6), and the High Capacity
Feeder C3-DS (Trays 6 and 7).
When loading postcards in the HCF B1-S (Tray 6) or the High Capacity Feeder C3-DS (Trays
6 and 7), attach the Post Card Kit to the tray.
The following describes how to load postcards in the High Capacity Feeder C3-DS (Tray 6)
as an example.
The procedure is the same as for the HCF B1-S (Tray 6) and the High Capacity Feeder C3-DS
(Tray 7).
For how to load a postcard in Tray 5 (Bypass), refer to "Loading Paper in Tray 5 (Bypass)"
(P.106).
Note
1
Pull out the tray towards you until it stops.
CAUTION
When pulling out the paper tray, do it
slowly. If pulled out with too much
force, the tray can hit and injure your
knees.
Important • While the machine is processing a job, do not pull the tray out that the job uses.
fill line. It might cause paper jams or machine
malfunctions.
• Carefully fan the paper before loading it in a tray. Otherwise, paper jams may occur or multiple
sheets may be fed to the machine simultaneously.
• When using postcards, you need to set the paper type for the paper tray to [Postcards], and the
paper weight corresponding to the postcard loaded in the tray. For the setting, refer to "Changing
the Paper Settings" (P.123).
• To prevent paper jams or misloading, do not add paper on top of any remaining paper in the tray.
Remove any paper remaining in the tray, and then load that paper on top of the newly loaded
paper.
Loading Tab Paper/Postcards/Envelopes
3
115