Fuji Xerox Versant 80 Press User Manual page 782

22 Problem Solving
Error Code
016-779 [Cause]
[Remedy] Retry scanning. If using large-size paper such as A3 with [Resolution] set to [600 dpi],
016-780 [Cause]
[Remedy] The hard disk may be defective. To replace the hard disk, contact our Customer Support
016-781
[Cause]
[Remedy] 1)Take one of the following measures:
22
016-786 [Cause]
[Remedy] Take one of the following measures:
016-788 [Cause]
[Remedy] Take one of the following measures, and then execute the operation again:
016-790
[Cause]
[Remedy] Take one of the following measures:
For more information on [Quality/File Size], refer to "Quality/File Size (Specifying an Image Compression Ratio When
Scanning)" (P.297).
For more information on [Maximum Split Count], refer to "Maximum Split Count" (P.507).
016-792 [Cause]
[Remedy] The specified job history does not exist.
782
Cause and Remedy
An error occurred during scanned image conversion processing.
specify [Resolution] to [400 dpi] or lower in [Layout Adjustment]. If the error still is not
resolved, contact our Customer Support Center.
A hard disk error occurred during scanned image conversion processing.
Center.
Probable causes are as follows:
1)The mail server cannot be found during e-mail sending (TCP/IP session establishment
failed).
2)The machine received an SMTP server error from the mail server during e-mail
sending.
- Check whether the network cables are plugged in securely.
- Check whether the IP address of the SMTP server when an IP address is used for
server specification.
2)Enter the host name of the machine using ASCII characters.
Available ASCII characters are follows:
- alphabets
- numerals
Check whether or not ASCII characters are used in [Tools] > [System Settings] >
[Connectivity & Network Setup] > [Machine's E-mail Address/Host Name].
When using the Scan feature, the machine could not write the file to the hard disk.
Switch off the machine power, make sure that the touch screen is blank, and then
switch on the machine power.
Load paper on the paper tray as necessary.
If the error occurs when sending an e-mail, take one of the following measures:
- Lower the resolution.
- Reduce the size.
- Reduce the number of pages, and divide the job into several e-mails to send.
- Send the job by setting [Color Scanning] to [Black & White].
Failed to retrieve a file from the Web browser.
Reload the browser page.
Restart the browser.
Switch off the machine power, make sure that the touch screen is blank, and then
switch on the machine power.
Unable to send an e-mail with Split Send because of exceeding the maximum number
of splits allowed.
Reduce the file size for [Quality/File Size].
Increase the value for [Maximum Split Count].
Failed to acquire the specified job history when printing a Job Report.