Paper Jams In The Interface Module - Fuji Xerox Versant 80 Press User Manual

2
Pull out the unit [4].
3
Turn the knob [4a] to the left to remove all the
jammed paper from the left side of the unit [4].
Note
4
Return the unit [4] to its original position.
5
Close the finisher right door.
Note

Paper Jams in the Interface Module

The following describes how to replace paper jams in the Interface Module when the
Finisher D4 (optional), the Finisher D4 with Booklet (optional), the Finisher D5 (optional) or
the High Capacity Stacker (optional) is installed.
Paper Jams at the Handle [1a] .................................................................................................................................................885
Paper Jams at the Handle [2b] .................................................................................................................................................886
Paper Jams at the Handle [2a] .................................................................................................................................................887
Note
Paper Jams at the Handle [1a]
1
Open the front door of the Interface Module.
• If paper is torn, check for any torn pieces of
paper inside the machine.
• A message will be displayed and the machine will not operate if the finisher right door is even
slightly open.
• A remedy differs depending on where the paper jam occurs. Follow the instructions displayed and
remove the jammed paper.
Paper Jams
22
885