Installation When Using Usb Port; Step 1 Preparations; Step 2 Configuration On The Machine - Fuji Xerox Versant 80 Press User Manual

15 Printer Environment Settings

Installation When Using USB Port

This section describes how to install the machine using a USB interface.

Step 1 Preparations

The following items are required to connect the machine to a computer via a USB interface.

Step 2 Configuration on the Machine

The following describes the configuration procedures to use a USB interface on the
machine.
Note
1
Display the [Tools] screen.
1) Press the <Log In/Out> button.
2) Enter the system administrator's user ID with the numeric keypad or the keyboard
Note
3) Select [Tools] on the Services Home screen.
2
Enable the USB port on the machine.
1) Select [Connectivity & Network Setup].
2) Select [Port Settings].
3) Select [USB], and then select [Change Settings].
4) Select [Port Status], and then select [Change Settings].
5) Select [Enabled], and then select [Save].
3
Configure [Print Mode] or [Auto Eject Time] as necessary.
15
For information on the setting items, refer to "USB" (P.468).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note
6
Print a configuration report to confirm that the USB port is enabled.
For information on how to print a configuration report, refer to "Printer Reports" (P.624).
566
Step 1 Preparations..................................................................................................................................................................... 566
Step 2 Configuration on the Machine .................................................................................................................................... 566
Step 3 Configuration on the Computer.................................................................................................................................. 567
CentreWare Internet Services Setting Items ........................................................................................................................ 567
USB cable
• You can configure the settings using CentreWare Internet Services. For items that can be configured
using CentreWare Internet Services, "CentreWare Internet Services Setting Items" (P.567).
displayed on the screen, and select [Enter].
When a passcode is required, select [Next] and enter the system administrator's
passcode, and select [Enter].
• The default user ID is "11111".
• The default passcode is "x-admin".
• Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.