Step 2 Registering A Folder; Step 3 Configuring A Computer - Fuji Xerox Versant 80 Press User Manual

3
Set an IP address and the other addresses.
Skip this step if an IP address is already set.
If DHCP or BOOTP is available in your environment, configure the method for obtaining the
address. If an IP address cannot be obtained automatically or manual configuration is
preferred, confirm the settings of an IP address, a subnet mask, and a gateway address.
For information on how to set an IP address, refer to "Protocol Settings" (P.473).
4
Select [Close] repeatedly until the [Tools] screen is displayed.
5
Select [Close].
Note
6
Print a configuration report to confirm that the WebDAV port is enabled and that TCP/IP is
set up correctly.
For information on how to print a configuration report, refer to "Print Reports" (P.622).

Step 2 Registering a Folder

Register a folder to store scanned data.
For information on registering a folder, refer to "Create Folder" (P.523).

Step 3 Configuring a Computer

To use Network Scanner Utility 3, install Network Scanner Utility 3 on a computer.
Network Scanner Utility 3 is included in the Software/Manual CD-ROM provided with the machine.
For information on the usage of the Network Scanner Utility 3, refer to "Computer Operations" (P.383).
• Rebooting the machine may be required depending on the settings. When a message displayed on
the screen, follow the message and reboot the machine.
Configuration of Store to Folder
585
17