Density Uniformity Adjustment (Manual Process); Density Uniformity Adjustment - Fuji Xerox Versant 80 Press User Manual

21 Maintenance

Density Uniformity Adjustment (Manual Process)

This section describes manual adjustment of the density uniformity.
Note

Density Uniformity Adjustment

You can adjust the density uniformity on the machine as follows:
1
Load paper in a tray.
2
Press the <Log In/Out> button, and then enter the System Administration mode.
For how to enter the System Administration mode, refer to "System Settings Procedure" (P.404).
3
Select [Tools] on the Services Home screen.
4
Select [System Settings] > [Common Service Settings] > [Maintenance].
5
Select [Density Uniformity Adjustment].
Note
21
6
Select [Manual Process].
7
Select the tray in which you loaded paper in
step 1, and then select [Print].
706
• Output paper for the density uniformity adjustment is counted for the number of printed pages. For
more information, refer to "Billing Information" (P.634)
• When using a smart card authentication system such as IC Card Gate, you may be requested
authentication before printing or scanning a calibration chart.
• Select [ ] to return to the previous screen or
[ ] to move to the next screen.
Coverage 1, 2
Two patterns of density for each color
(Yellow, Magenta, Cyan, and Black) could be
set for the sample output.
Full Color / Single Color
Select [Full Color] to check the density and balance of all colors. Select [Single Color] to
check the density of a specific color.
f you selected [Single Color], select the color to print from [Yellow], [Magenta], [Cyan],
and [Black].
Paper Supply
Select the tray with the paper to adjust density.