Fuji Xerox Versant 80 Press User Manual page 217

3
Load the document face up (when the
document is 2-sided, place the front side up)
in the center of the document feeder.
Note
Document Glass
The document glass supports a single sheet, a book, or other similar documents with sizes
up to 297 x 432 mm (Standard size: A3, 11 x 17").
Important • Always close the document cover after using the document glass.
The document glass automatically detects standard size documents. For non-standard size
documents, enter the size on the [Original Size] screen.
For information on document sizes that can be detected automatically and how to enter a non-standard document size,
refer to "Original Size (Specifying a Scan Size)" (P.291).
The standard document sizes that can be detected automatically depend on [Paper Size Settings] in the System
Administration mode. For information on the paper size settings, refer to "Paper Size Settings" (P.447).
CAUTION
Do not apply excessive force to hold thick document on the document glass. It may
break the glass and cause injuries.
1
Open the document cover.
Important • Ensure that the touch screen is active, and
2
Load the document face down, and align it
against the top left corner of the document
glass.
3
Close the document cover.
• The Confirmation indicator lights up when
the document is loaded correctly.
• The number of documents that can be
loaded in the document feeder is up to 250
sheets (P paper).
• When the document is loaded in the
document feeder, the document feeder tray
lifts up. You can set the timing of the lift. For
more information, refer to "Document Feeder Tray Elevation" (P.456).
then load a document. Otherwise, the
machine may not properly detect the
document size.
Scanning Procedure
Confirmation indicator
217
5