Fuji Xerox Versant 80 Press User Manual page 200

4 Copy
For the stapling position, refer to "Paper Size and Stapling Position" (P.201).
Important • Ensure that the actual orientation of the original document matches the [Original Orientation]
Hole Punch
Sets the position for punching.
The positions for punching vary depending on a finisher installed.
For the hole punching position, refer to "Paper Size and Punching Position" (P.203).
Important • Ensure that the actual orientation of the original document matches the [Original Orientation]
Original Orientation
Allows you to specify the orientation of the document so that the machine can identify the
top of the document.
Note
4
Upright Images
Select this option when placing the top edge of the document against the top side of the
document glass or document feeder.
Sideways Images
Select this option when placing the top edge of the document against the left side of the
document glass or document feeder. Always select [Sideways Images] when the top of
the document is placed facing the left side (horizontal text).
Z Fold Half Sheet
When the D4/D5 Folder Unit (optional) is installed, the machine folds the output copies in
Z fold. Z fold can be applied to B4, A3, 11 x 17". If you have mixed sized documents, the
width (vertical direction) of the paper must be the same, such as a combination of A4
(portrait) and A3 (landscape), and a combination of B5 (portrait) and B4 (landscape). When
you have the combinations, the Z fold is only applied to the larger papers (A3 (landscape)
and B4 (landscape)).
Output Destination/Offset
Offset Stacking
This option is displayed if you select [Right Middle Tray] or [Stacker - Stacker Cart] for the
output destination.
The offset is a function for slightly offsetting and outputting each paper stack to allow
you to distinguish the separations.
You can specify by set, job, specified number of pages, or specified number of copies for
a paper stack.
Real Time Sample Job
This option is displayed if you select [Stacker - Stacker Cart] for the output destination,
and you can output samples of specified portions. You can specify up to three portions for
each of the sets you want to confirm during sorting and the pages you want to confirm
during stacking. Samples are output to the output tray at the top of stacker trays.
200
setting on the [Layout Adjustment] screen.
• In the following cases, the actual stapling position differs from the stapling position displayed on
the screen:
- When [Original Orientation] is set to [Upright Images], and [Staple] is set to one position at the
right side.
- When [Original Orientation] is set to [Sideways Images], and [Staple] is set to one position at the
left side.
setting on the [Layout Adjustment] screen.
• If the [Original Orientation] setting differs from the actual document orientation, the machine may
not detect the top of the document correctly.