Fuji Xerox Versant 80 Press User Manual page 828

22 Problem Solving
Error Code
027-776 [Cause]
[Remedy] Use ASCII characters to modify the host name that has been specified under [Tools] >
027-777 [Cause]
[Remedy] Set [E-mail Send Authentication] to [Off] under [Tools] > [System Settings] >
027-778
[Cause]
[Remedy] Confirm the authentication type supported by the SMTP server with your network
027-779
[Cause]
[Remedy] Confirm the login name and password set to SMTP-AUTH.
027-796 [Cause]
[Remedy] To print the mail body or header information also, change settings in the [Properties]
22
Refer to "E-mail Printing" (P.389).
027-797 [Cause]
[Remedy] Specify a correct output destination, and send the e-mail again.
027-798 [Cause]
[Remedy] Check the job flow setting.
041-227 [Cause]
041-228
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
041-310 [Cause]
041-388
[Remedy] Switch off the machine power, make sure that the touch screen is blank, and then switch
828
Cause and Remedy
An error occurred during communication with the SMTP server.
[System Settings] > [Connectivity & Network Setup] > [Machine's E-mail Address/Host
Name]. If the error still is not resolved, confirm with your network administrator whether
the SMTP server supports the EHLO command.
The destination SMTP server does not support SMTP-AUTH.
[Connectivity & Network Setup] > [Outgoing/Incoming E-mail Settings] > [SMTP Server
Settings].
The destination SMTP server does not support the SMTP-AUTH system set on the
machine.
administrator. The machine supports the following authentication types: AUTH GSSAPI
(only for Kerberos), AUTH NTLMv2, AUTH NTLMv1, AUTH PLAIN, AUTH LOGIN, AUTH
CRAM-MD5.
Failed to authenticate the SMTP server.
The received e-mail was discarded because no documents were attached to it. (The
machine is set to print attached documents only.)
screen of CentreWare Internet Services.
The output destination of the received e-mail is invalid.
The specified document did not exist.
An error occurred in the machine.
on the machine power. If the same message is displayed again, turn the power of both
of the external controller and the machine off and on. If the same message is displayed
again, contact our Customer Support Center.
An error occurred.
on the machine power. If the same message is displayed again, contact our Customer
Support Center.