Fuji Xerox Versant 80 Press User Manual page 668

21 Maintenance
4
Pinch both sides of the empty staple case with
your fingers (1), and pull out the staple case
from the cartridge (2).
Important • The staple case cannot be removed when the
5
Insert the front side of the new staple case into
the staple cartridge (1), and then push the rear
side into the cartridge (2).
6
With grasping the orange lever of the staple
cartridge, push the staple cartridge into its
original position until it clicks into place.
21
7
Close the finisher front door.
Note
When the Finisher D4, the Finisher D4 with Booklet, or the Finisher D5 is installed
The following describes how to replace a staple cartridge for the Finisher D4 with Booklet as
an example. The procedure is the same as for the Finisher D4 and the Finisher D5.
For remedies if the staple cartridge happened to come off the holder during replacement
work, refer to "Re-inserting the Staple Cartridge into the Cartridge Unit" (P.911).
1
Make sure that the machine has stopped, and
open the finisher right door.
668
staples are remained in the staple case.
Forcibly removing the staple case may cause
machine malfunction.
• If the front door is not closed completely, a message appears and the machine will remain paused.
2
1
1
2
1