Fuji Xerox Versant 80 Press User Manual page 964

23 Appendix
Parameter
Position
adjustment
Number of sets
Print control
23
964
Item No.
113 Adjusts the hard clip area vertically or horizontally. You can set from -250 mm
(Vertical to +250 mm in 1 mm increments.
position [0] (Default) : Does not move the hard clip area.
adjustment) [1] - [250]
[251] - [500] : +1 to +250 mm
114
(Horizontal
Important • Data outside the printable area is not printed regardless of the adjustment
position
adjustment)
115 Sets the method for specifying the print sets.
[0] (Default) : Protocol
[1]
[2]
150 Selects a graphics language. This setting affects to IW, OW, and UC of HP-GL/
(HP-GL mode) 2 commands.
[0] (Default) : HP-GL
[1]
Note • To print HP-GL/2 command that does not include BP command, select [HP-
151 Sets the size of hard clip area.
(Hard clip) In HP-GL mode, the plottable area is determined in line with the paper size,
apart from the printable area. This area is called the "hard clip area", and
determines the maximum range of pen movement. Accordingly, images
cannot be drawn outside the boundary of the hard clip area.
[0]
[2] (Default) : Paper
For more information on hard clip area, refer to "Hard Clip Area" (P.967).
152 (Eject Sets the command that indicates the end of plotting. When the command
command SP) specified here is received, plotting is terminated and the paper is output.
[0] (Default) : OFF
153 (Eject
[1]
command
The default value is [ON] for SPO, and [OFF] for the others.
SPO)
Note • If multiple commands are specified, when one of the commands is
154 (Eject
command NR)
155 (Eject
command FR)
156 (Eject
command PG)
157 (Eject
command AF)
158 (Eject
command AH)
Value
: -1 to -250 mm
of the print position. In addition, data moved outside the printable area as
a result of adjusting the print position is not printed.
: Panel
: Command
: HP-GL/2
GL/2].
: Standard
: ON
received, plotting is terminated and the paper is output.