Fuji Xerox Versant 80 Press User Manual page 906

22 Problem Solving
1
Make sure that the machine has stopped, and
open the finisher right door.
2
Hold [R1] at the position shown in the figure.
3
Pull out the unit.
Note
22
4
Open the cover of the unit as shown in the
figure and remove the jammed staples.
5
Push the removed staple cartridge back to its
original position.
6
Close the finisher right door.
Note
If the staples cannot be removed after carrying out the above procedures, contact our
Customer Support Center.
906
• After removing the unit, check the inside of
the finisher for any remaining staples.
CAUTION
Be careful in removing
jammed staples.
• A message will be displayed and the machine will not operate if the finisher right door is even
slightly open.