Stapler Faults - Fuji Xerox Versant 80 Press User Manual

Stapler Faults

The following describes how to clear stapler troubles when the finisher (optional) is installed.
Follow the procedures on the following pages when outputs are not stapled or staples are
bent. Contact our Customer Support Center if the problem persists after you have tried the
following solutions.
If outputs are stapled as shown in the figures below, contact our Customer Support Center.
Important • Depending on the type of paper that is being stapled, the stapled nails may be bent. If the bent nails
Unstapled
One side of staple rising up
Flattened staple
are stuck inside the machine, they may eventually cause paper jams.
• Remove the bent staple when opening the staple cartridge cover. If you do not remove the bent
staple, a staple jam may occur as a result. Open the staple cartridge cover only when removing the
bent staple.
Bent staple
Staple bent in reverse direction
Entire staple rising up
Staple rising up with
center pressed in

Stapler Faults

22
903