Fuji Xerox Versant 80 Press User Manual page 854

22 Problem Solving
Paper Jams in Tray 5 (Bypass)
1
Open Tray 5 (Bypass) top cover to remove the
jammed paper.
2
Remove all paper loaded in Tray 5 (Bypass).
Important • When two or more sheets of paper are
Note
3
Close the top cover.
4
Align all four corners of the removed paper neatly.
5
Insert the paper into the tray with the printing
22
side facing up and place the leading edge of
the paper against the paper feed entrance.
Note
Paper Jams in the Transfer Module
Important • Before pulling out the transfer module, check the touch screen to make sure that no paper remains
Do not attempt to remove a paper deeply jammed inside the product, particularly
a paper wrapped around the fusing unit or the heat roller. Otherwise, it may cause
injuries or burns. Switch off the product immediately and contact your local Fuji
Xerox representative.
854
loaded, remove all sheets from the tray.
• If paper is torn, check for any torn pieces of
paper inside the machine.
• Do not load paper exceeding the maximum
fill line ("MAX" in the right figure). It may
cause paper jams or machine malfunctions.
in the left/right cover of the machine, Tray 5 (Bypass), the output exit, the optional high capacity
feeder or finisher. Paper may be torn if paper remains in these locations when the transfer module is
pulled out.
• Be sure to remove the jammed paper in the areas [2a] and [2c] first, and then remove the paper at
the handles [2b], [2d] and [2e].
CAUTION