Front Suspension Frame Check; Front Stabilizer Bar, Bushing And/Or Joint Check; Front Suspension Fasteners Check - Suzuki 2006 SX4 Service Manual

12) Install exhaust No.1, No.2 and center pipe referring
to "Exhaust System Components in Section 1K".
13) Install wheel and tighten nut to specified torque.
Tightening torque
Wheel nut: 85 N·m (8.5 kgf-m, 61.5 lb-ft)
14) Install air cleaner assembly referring to "Air Cleaner
Assembly Removal and Installation in Section 1D".
15) Install hood referring to "Hood Removal and
Installation in Section 9J".
16) Lower hoist and vehicle in unloaded condition,
tighten suspension control arm bolts to specified
torque.
Tightening torque
Suspension control arm bolt: 95 N·m (9.5 kgf-m,
69.0 lb-ft)
17) Connect negative (–) cable at battery.
18) Confirm front wheel alignment referring to "Front
Wheel Alignment Inspection and Adjustment".

Front Suspension Frame Check

Inspect for cracks, deformation or damage.
If defective, replace.
Front Stabilizer Bar, Bushing and/or Joint
Check
Stabilizer Bar
Inspect for damage or deformation.
If defective, replace.
Stabilizer Bushing
Inspect for damage, wear or deterioration.
If defective, replace.
Stabilizer Joint
1) Check for smooth rotation.
2) Check damages of ball stud.
3) Check damages of dust cover.
NOTE
S6RW0D2206017
Stabilizer joint (1) cannot be disassembled.
If there is any damage to either parts, stabilizer joint
must be replaced as a complete unit.
I5RW0A220034-01
S6RW0D2206018

Front Suspension Fasteners Check

Check each bolt and nut fastening suspension parts for
tightness. Tighten loose one, if any, to specified torque,
referring to "Front Suspension Construction".
I5RW0A220035-01
Front Suspension: 2B-20
I5RW0A220036-01
1
I4RH01220007-01
S6RW0D2206019