Subaru 2002 IMPREZA Service Manual page 1258

DIAGNOSTIC PROCEDURE WITH DIAGNOSTIC TROUBLE CODE (DTC)
ENGINE (DIAGNOSTICS)
Step
5 CHECK HARNESS BETWEEN ECM AND
MASS AIR FLOW SENSOR CONNECTOR.
1)Turn the ignition switch to OFF.
2)Disconnect the connector from ECM.
3)Measure the resistance of harness between
ECM and mass air flow sensor connector.
Connector & terminal
(B84) No. 13 — (B3) No. 3:
(B135) No. 27 — (B3) No. 4:
(B135) No. 19 — (B3) No. 5:
6 CHECK HARNESS BETWEEN ECM AND
MASS AIR FLOW SENSOR CONNECTOR
Measure the resistance of harness between
ECM and chassis ground.
Connector & terminal
(B84) No. 13 — Chassis ground:
(B135) No. 27 — Chassis ground:
(B135) No. 19 — Chassis ground:
7 CHECK POOR CONTACT
Check poor contact in mass air flow sensor
connector.
Check
Is the resistance less than 1Ω? Go to step 6.
Is the resistance more than
1MΩ?
Is there poor contact in mass
air flow sensor connector?
EN(TURBO)-98
Yes
Repair the open
circuit between
ECM and mass air
flow sensor con-
nector.
Go to step 7. Repair the ground
short circuit
between ECM and
mass air flow sen-
sor connector.
Repair the poor Replace the mass
contact in mass air air flow and intake
flow sensor con- air temperature
nector. sensor. <Ref. to
FU(TURBO)-34,
Mass Air Flow and
Intake Air Temper-
ature Sensor.>
No