Subaru 2002 IMPREZA Service Manual page 1123

25) Install the water pump and gasket.
Tightening torque:
First; 12 N·m (1.2 kgf-m, 8.7 ft-lb)
Second; 12 N·m (1.2 kgf-m, 8.7 ft-lb)
CAUTION:
• Be sure to use a new gasket.
• When installing the water pump, tighten bolts
in two stages in alphabetical sequence as
shown in the figure.
26) Install the water by-pass pipe for heater.
27) Install the oil cooler.
Tightening torque:
T1: 55 N·m (5.5 kgf-m, 40 ft-lb)
T2: 69 N·m (7.0 kgf-m, 50.6 ft-lb)
(A) O-ring
(B) Oil cooler
(C) Connector
28) Install the oil filter using ST.
ST 498547000 OIL FILTER WRENCH
CYLINDER BLOCK
29) Install the water by-pass pipe between oil cool-
er and water pump.
30) Install the water pipe.
NOTE:
Always use a new O-ring.
31) Install the cylinder head assembly. <Ref. to
ME(TURBO)-64, INSTALLATION, Cylinder Head
Assembly.>
32) Install the oil level gauge guide and tighten the
H2M1846D
attaching bolt (left side only).
33) Install the rocker cover.
34) Install the crankshaft sprocket. <Ref. to
ME(TURBO)-58,
Sprocket.>
35) Install
ME(TURBO)-57,
Sprocket.>
36) Install the timing belt assembly. <Ref. to
ME(TURBO)-50, INSTALLATION, Timing Belt As-
sembly.>
37) Install the belt cover. <Ref. to ME(TURBO)-47,
INSTALLATION, Belt Cover.>
38) Install the crankshaft pulley. <Ref. to ME(TUR-
BO)-46, INSTALLATION, Crankshaft Pulley.>
39) Install the generator and A/C compressor
brackets on cylinder head.
40) Install the V-belt. <Ref. to ME(TURBO)-45, IN-
STALLATION, V-belt.>
41) Install the intake manifold. <Ref. to FU(TUR-
BO)-15, REMOVAL, Intake Manifold.>
EN0320
ME(TURBO)-81
INSTALLATION,
the camshaft sprocket.
INSTALLATION,
MECHANICAL
EN0321
Crankshaft
<Ref. to
Camshaft