Compulsory Valve Operation Check Mode - Subaru 2002 IMPREZA Service Manual

COMPULSORY VALVE OPERATION CHECK MODE

ENGINE (DIAGNOSTICS)
14.Compulsory Valve Operation
Check Mode
A: OPERATION
1) Prepare the Subaru Select Monitor kit. <Ref. to
EN(TURBO)-7, PREPARATION TOOL, General
Description.>
2) Connect the diagnosis cable to Subaru Select
Monitor.
3) Insert the cartridge into Subaru Select Monitor.
<Ref. to EN(TURBO)-7, PREPARATION TOOL,
General Description.>
4) Connect the test mode connector (A) at the low-
er portion of instrument panel (on the driver's side).
(A)
5) Connect the Subaru Select Monitor to data link
connector.
(1) Connect the Subaru Select Monitor to data
link connector located in the lower portion of in-
strument panel (on the driver's side).
(2) Connect the diagnosis cable to data link
connector.
CAUTION:
S2M0285
Do not connect scan tools except for the
Subaru Select Monitor and OBD-II general scan
tool.
6) Turn the ignition switch to ON (engine OFF) and
Subaru Select Monitor switch to ON.
S2M0286A
7) On the «Main Menu» display screen, select the
{2. Each System Check} and press [YES] key.
8) On the «System Selection Menu» display
screen, select the {Engine Control System} and
press [YES] key.
9) Press the [YES] key after displayed the informa-
tion of engine type.
10) On the «Engine Diagnosis» display screen, se-
lect the {System Operation Check Mode} and press
[YES] key.
11) On the «System Operation Check Mode» dis-
play screen, select the {Actuator ON/OFF Opera-
tion} and press [YES] key.
EN0773
12) Select the desired compulsory actuator on the
«Actuator ON/OFF Operation» display screen and
press [YES] key.
EN(TURBO)-46
EN0768
S2M0288A