Subaru 2002 IMPREZA Service Manual page 1075

9. Engine Assembly
A: REMOVAL
1) Set the vehicle on lift arms.
2) Open the front hood fully, and then support with
the hood stay.
3) Raise the rear seat, and then turn the floor mat
up.
4) Release the fuel pressure.
(1) Disconnect the fuel pump relay connector.
(2) Start the engine, and run until stalls.
(3) After the engine stalls, crank it for 5 seconds
more.
(4) Turn the ignition switch to OFF.
5) Remove the filler cap.
6) Disconnect the ground cable from battery.
7) Remove the radiator from vehicle. <Ref. to CO-
39, REMOVAL, Radiator.>
8) Remove the coolant filler tank. <Ref. to CO-53,
REMOVAL, Coolant Filler Tank.>
ENGINE ASSEMBLY
9) Collect refrigerant, and then remove the pres-
sure hoses.
(1) Place and connect the attachment hose to
the refrigerant recycle system.
(2) Collect the refrigerant from A/C system.
(3) Disconnect the A/C pressure hoses from
A/C compressor.
10) Remove the intercooler. <Ref. to IN(TURBO)-
10, REMOVAL, Intercooler.>
EN0344
11) Disconnect the following connectors and cable.
(1) Engine harness connector
(2) Engine ground terminal
G6M0095
ME(TURBO)-33
MECHANICAL
S2M1584
S2M2260
S2M0731