Subaru 2002 IMPREZA Service Manual page 1093

2. TIMING BELT
1) Preparation for installation of automatic belt ten-
sion adjuster assembly. <Ref. to ME(TURBO)-50,
AUTOMATIC BELT TENSION ADJUSTER AS-
SEMBLY AND BELT IDLER, Timing Belt Assem-
bly.>
2) Crankshaft and camshaft sprocket alignment.
(1) Align mark (A) on the crankshaft sprocket
with mark on the oil pump cover at cylinder
block.
(A)
(2) Align single line mark (A) on the exhaust
camshaft sprocket (RH) with notch (B) on belt
cover.
(3) Align single line mark (A) on the intake cam-
shaft sprocket (RH) with notch (B) on belt cover.
(Make sure double lines (C) on intake camshaft
and exhaust camshaft sprockets are aligned.)
TIMING BELT ASSEMBLY
EN0243
S2M1227B
S2M1228B
ME(TURBO)-51
(4) Align single line mark (A) on exhaust cam-
shaft sprocket (LH) with notch (B) on belt cover
by turning the sprocket counterclockwise (as
viewed from front of engine).
(5) Align the single line mark (A) on intake cam-
shaft sprocket (LH) with notch (B) on belt cover
by turning the sprocket clockwise (as viewed
from front of engine).
Ensure the double lines (C) on intake and ex-
haust camshaft sprockets are aligned.
MECHANICAL
S2M1229B
S2M1230B